OMG, I can see ever piece of Foam on the wall
If you can see every piece of foam on the wall the applicator has missed a crucial step
The other day a came across an EIFS house that I could see every piece of foam on. I have seen some EIFS applications where in the right sunlight you could see a few pieces of foam, but this was the worst you could literally see every piece of foam. The home owner naturally asked me how this could have happened. Apparently the contractor told him that is just how it looks. I can tell you that, that is not true. There is a few reasons that could have happened and in this case it was probably all of the above. If the foam is not rasped or rasped correctly you will be able to see the foam pieces after the job is done. Also, the adhesive used to adhere the foam to the wall can get in between the pieces, and cause gaps. The gaps will dry at a different rate due to moisture and heat flow, and that will cause them to be seen. I have purchased foam that was not all exactly the same thickness, which if not rasped down will cause the pieces to be seen, but this is very rare I have only seen this a couple times in my 23 years in the industry.
In the case I just seen I am sure they did not rasp the foam at all, and when sticking the foam they did not make sure the pieces where applied tightly together, which caused the finished product to look like that. To fix the wall it now needs to coated with two layers of base coat. The first layer to fill in all the seams to even them out. The second layer is a complete coat over the entire wall to blend everything together. This process to repair the wall takes a highly skilled plasterer. Short of that you would have to re-stick the entire wall, essentially redoing the wall over the existing EIFS.
EIFS – EIFS Repair – Synthetic Stucco